How To Repair The Rubber Grip On A Nikon D3300?
If y'all've endemic a Nikon DSLR for a couple years with reasonably heavy use you're probably more familiar with the problem with the rubber grips, for me its been the thumb grip in particular.
Basically the rubber wears thin, the agglutinative comes loose and the safe stretches out from the cut out expanse and pretty much becomes an irreparable annoyance. Information technology likewise seems this is more prevalent with heavier bodies like the D700. On the plus side it's a quick and easy fix.
Quondam grip - noticeably thinning and stretched across housing
i. Kickoff of all you lot need to track downward the grip you crave. Ebay is a good place to start and is where I got my pollex slice for about $15-20US just at that place are plenty of other places that stock them. Evidently Nikon USA sells them directly to the public, even so I have withal to confirm this for Nikon AU confirmed – these are also available through Nikon AU (thank you Aaron!). The best thing is they come up with the OEM adhesive tape already on and then application is quick and tidy. Yous'll also demand some toothpicks, cotton tips and acetone (products like "Goo off" are good choices too).
Step #2 - Old adhesive strip - melted, full of crud, sweat and clay
ii. Peel off the old rubber, don't worry there's no sensitive parts underneath
Step #3 - Pick
3. Apply a toothpick or similar scraper to scratch away every bit much of the old adhesive and gunk as possible. I found it works best if y'all brawl up the adhesive to collect the smaller $.25 as y'all go, kind of similar Blutack. Be certain to clear the access screw expanse, in case your camera ever needs servicing.
Footstep #4 - Swab
iv. Take a cotton wool tip and dip information technology lightly into the Acetone. Use this very sparingly equally it will strip a little colour from the plastic housing, but dont fret, its completely unnoticeable. Go over information technology a few times, using a fresh tip each time to gradually pick up the pilled adhesive. Eventually it will be smooth (other than the texture of the casing) and non pasty to bear on. After this I did a one time over with a cotton fiber tip dipped in water to pick upward any devious grit and lint.
Pace #5 - Affix
v. Once its dry, stick the new rubber slice on. It fits perfectly and so you either get it in the right spot or you don't. Apply pressure for a minute or ii to permit the agglutinative to bond and yous're done! Your camera's original textured grippy goodness has been restored and y'all saved some dollars in doing so. I'd say replacing the other grips would be only as easy.
Notation 1: When your photographic camera is serviced, the grips are usually removed to proceeds admission to the torso screws. The service center will say they lovingly replaced the grips while they were at information technology but actually its considering they had to, of course you lot will be charged for that lovely courtesy.
Note 2: This is a guide just, if y'all feel uncomfortable with undertaking this, pay a professional person to practice it for you. No responsibility will be held for accidents or plain stupidity :p
Comments
How To Repair The Rubber Grip On A Nikon D3300?,
Source: http://www.soulbridgemedia.com/news/?p=1918
Posted by: smithdesichall74.blogspot.com
0 Response to "How To Repair The Rubber Grip On A Nikon D3300?"
Post a Comment